من این تنظیمات را انجام دادم از همان اول بعد یک برنامه خیلی ساده نوشتم با cmsis بعد از طریق jlink امدم برد پروگرام کنم گزینه پروگرام را که زدم نوشت باید حافظه فلش میکرو پاک بشه منم گزینه yes زدم بعد از اون وقت صفحه تاچ برد سفید شد و چیزی نشان نمیده با کیل هم که می خوام برد را پروگرام کنم در build out این را مینویسه
Build target 'firstproject'
linking...
Program Size: Code=2476 RO-data=236 RW-data=16 ZI-data=608
FromELF: creating hex file...
"firstproject.axf" - 0 Error(s), 0 Warning(s).
Load "D:\\arm nxp\\project\\firstproject.AXF"
JLink info:
-----------
DLL: V4.11i, compiled Jan 28 2010 19:55:25
Firmware: J-Link ARM-OB STM32 compiled Dec 15 2010 11:30:03
Hardware: V7.00
S/N : 377001345
Feature(s) : RDI,FlashDL,FlashBP,JFlash,GDBFull
---
* JLink Info: TotalIRLen = 4, IRPrint = 0x01
* JLink Info: Found Cortex-M3 r2p0, Little endian.
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
* JLink Info: TotalIRLen = 4, IRPrint = 0x01
* JLink Info: Found Cortex-M3 r2p0, Little endian.
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
Target info:
------------
Device: LPC1768
VTarget = 3.300V
State of Pins:
TCK: 1, TDI: 0, TDO: 1, TMS: 0, TRES: 1, TRST: 1
* JLink Info: TotalIRLen = 4, IRPrint = 0x01
* JLink Info: Found Cortex-M3 r2p0, Little endian.
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
Hardware-Breakpoints: 6
Software-Breakpoints: 2048
Watchpoints: 4
JTAG speed: 50 kHz
---
* JLink Info: TotalIRLen = 4, IRPrint = 0x01
* JLink Info: Found Cortex-M3 r2p0, Little endian.
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
Erase Done.
Programming Done.
Verify OK.
* JLink Info: TotalIRLen = 4, IRPrint = 0x01
* JLink Info: Found Cortex-M3 r2p0, Little endian.
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
**JLink Warning: CPU did not halt after bootloader.
Application running ...